This pressure switch signals the pump to start when the water system drops to 30 PSI (factory set) and stops at 50 PSI (factory set). This switch is to be used with submersible well or jet pumps. It can be wired 115-Volt or 230-Volt. This switch must be used in conjunction with a well pressure tank. The air pressure in the well tank, when empty of all water, must be set to 28 PSI, or the switch will not operate properly. This switch is equipped with a low-level cut-off arm that automatically shuts off a well pump when there is a dramatic decrease in pressure, such as a leak in the discharge pipes or a faulty pressure tank.
Turns pump on at 30 psi, off at 50 psi.
Cap removes for easy adjustment.
Can be wired 115-Volt or 230-Volt.
For use with submersible well or jet pumps.
Motor wires are connected to the 2 middle posts (color does not matter).
Breaker box wires are connected to 2 outside posts (color does not matter).
2-spring design allows for adjustment of cut-in and cut-out pressure settings.
Adjustments to springs should only be made by users with good knowledge of well systems.
Switch shuts off pump automatically when there is a dramatic decrease in pressure.
The Apollo 1/2 in. CPVC x Male Threaded Transition Adapter is simple to install and is designed for transitioning from CPVC to alternative piping systems. It is designed for use within hot and cold water pressure piping systems in all commercial and residential applications. The CPVC x Male Threaded Transition Adapter features a female solvent weld socket and a male threaded stainless steel connection. The fitting is used in applications where a change in the piping material is necessary.
Compatible with CPVC pipe.
Solvent weld slip x stainless steel male pipe thread (MPT) connection.
Not compatible with gases or compressed air.
Used to transition from CPVC piping system to alternative piping systems.
BrassCrafts Safety+PLUS2 gas connector combines patented excess flow technology and thermal heat activation with the advanced corrosion resistance, to provide a safer gas connector for your home and family. In the event of a gas line rupture or disconnect, the excess flow valve (EFV) restricts gas flow at the appliance to a non-hazardous level. This immediate action helps avert the potential for a dangerous release of gas into the home. Gas is controlled only at the point where the problem exists; the rest of your system will continue to function. Safety+PLUS EFV automatically resets once the gas line is properly repaired. The thermal component utilizes a thermal ring that will restrict the flow through the valve when the valve is exposed to temperatures of 400F or more. BrassCraft’s stainless steel gas connector also features a proprietary polymer coating designed to withstand prolonged exposure to harsh household cleaning, plumbing repair and masonry products as well as UV rays and salt. Unlike conventional dipped or sprayed coatings, the ProCoat coating is baked directly on the connector surface at high temperatures to provide a uniform coating over the entire length of the connector. The coating is applied only after the connector has been 100% leak tested to provide complete corrosion resistance.
BrassCraft has created an easy-to-install, one-piece connection. By combining our trusted bass supply stops with our dependable braided, vinyl and stainless steel connector – the results is a quick and easy installation. One-piece connectors are available in a wide variety of options for faucet, toilet and dishwasher applications.
Connector is constructed with flexible braided polymer; stop is chrome plated brass.
1/2 in. nominal push connect x 1/2 in. FIP.
No special installation tools required.
Use in hot or cold water applications.
Durable, flexible water connector requires no cutting or soldering during installation.
Compatible with copper, PEX, and CPVC.
Remove with combination removal tool or 5/8 in. open end wrench.
Connector bends freely without kinking or crimping in tight quarters.
No-lead certified.
IAPMO and CSA listed to ASME A112.18.1/CSA B125.1.