-
BrassCraft Safety+PLUS2 Thermal Excess Flow valve (36,800 BTU) 1/2 in. MIP x 1/2 in. MIP x 24 in. Gas Connector
$27.27 $15.00BrassCraft’s Safety+PLUS2 gas connector combines patented excess flow technology and thermal heat activation with the advanced corrosion resistance, to provide a safer gas connector for your home and family. In the event of a gas line rupture or disconnect, the excess flow valve (EFV) restricts gas flow at the appliance to a non-hazardous level. This immediate action helps avert the potential for a dangerous release of gas into the home. Gas is controlled only at the point where the problem exists; the rest of your system will continue to function. Safety+PLUS EFV automatically resets once the gas line is properly repaired. The thermal component utilizes a thermal ring that will restrict the flow through the valve when the valve is exposed to temperatures of 400°F or more. BrassCraft’s stainless steel gas connector also features a proprietary polymer coating designed to withstand prolonged exposure to harsh household cleaning, plumbing repair and masonry products as well as UV rays and salt. Unlike conventional dipped or sprayed coatings, the ProCoat coating is baked directly on the connector surface at high temperatures to provide a uniform coating over the entire length of the connector. The coating is applied only after the connector has been 100% leak tested to provide complete corrosion resistance.
- Corrugated stainless steel with corrosion resistant coating.
- 1/4 in. ID (3/8 in. OD).
- Connectors and fittings can be used with natural gas, LP gas (propane) and LP gas-air mixtures.
- Use to install 4-burner gas ranges, cook-top, dryers and water heaters.
- Safety+Plus2 TEFV valve helps protect against fires and explosions.
- Valve has no parts that can break or misalign over time for 24/7 protection.
- Connector and valve are 100% leak tested.
- No special tools required for installation.
- ProCoat coating corrosion resistant to most household chemicals, UV rays and salt.
- Approved for indoor and outdoor use.
- Temperature rating: -20°F to 150°F.
- Pressure rating: 1/2 psi maximum.
- ANSI Z21.24-2015/CSA 6.10-2015 and ANSI Z21.75-2016/CSA 6.27-2016, ANSI Z21.93-17/CSA 6.30-17.
- Designed, machined and assembled in the USA.
Every item checked for quality -
BrassCraft 1/2 in. Nominal Push Connect x 1/2 in. FIP x 20 in. SpeediOne Braided Faucet Connector and 1/4-Turn Straight Valve
$3.64 $2.00Original Retail Price: $17.75.
BrassCraft’s push connect one-piece water supply combines their trusted brass water valve with their flexible braided polymer connector for one quick easy-to-install solution. BrassCraft’s one-piece connection features push connect technology on the valve inlet and a hand-tighten wing nut on the outlet to provide a significant savings in installation time and cost. Push connect valve inlet requires no special tools to install and comes equipped with a pre-inserted tube stiffener to make the product ideal for copper, PEX and CPVC piping systems. The braided polymer fibers of the connector are designed to bend freely without kinking or crimping in tight quarters and resist corrosion caused by chemicals found in common household, tile and glass cleaners. In addition, its reinforced inner hose resists corrosion under harsh water conditions.
- 1-piece unit combines valve and supply line.
- Saves time with one less connection.
- No special installation tools required.
- Installation ready with pre-inserted tube stiffener.
- Fast, reliable and secure.
- Compatible with copper, PEX and CPVC.
- Remove with combination removal tool or 5/8 in. open end wrench.
- Connector bends freely without kinking or crimping in tight quarters.
- No-lead certified.
- IAPMO and CSA listed to ASME A112.18.1/CSA B125.1.
Every item checked for quality -
Greenworks PRO 60V Dual Port Turbo Charger
$137.00 $75.35Our 6.0 Amp hour (Ah) battery charger is designed to charge all Greenworks 60-Volt tools. Charges includes a diagnostic LED indicator communicating current charge level, battery temperature and indicate battery issues.
- Simultaneously charges 2 batteries.
- Compatible with all Greenworks 60-Volt batteries.
- Can be used bench top or mounted on the wall.
Every item checked for quality -
ECHO YOUCAN Fuel System Kit 225 Series Models
$14.98 $8.24Keep your ECHO equipment running like new by extending engine performance and longevity with the 90127Y Fuel System Kit. Fuel system components are vital to engine health. Regular fuel system maintenance will prevent dirt and debris from entering your carburetor. Blocked or partially clogged fuel filters will cause hard starting and low power output. Being proactive with routine maintenance can save you time, money, and downtime. The Fuel System Kit contains genuine ECHO replacement parts.
- Includes: fuel filter, fuel lines, grommet, fuel cap, gasket, fuel tank vent and purge bulb.
- For use on: ECHO trimmers, brushcutters, edgers, and power attachment series (PAS).
- Fits models: GT-225/i/L/SF, SRM-225/i/SB/U, PE-225, PAS-225/SB.
- Fuel components should be inspected every 3 months or 90 hours, or per your operators manual, and replaced on a yearly basis.
- Product is regulated for use with off-road engines and equipment under EPA 40 CFR Part 1060 and must be used on engines/equipment built after 1/1/2012.
Every item checked for quality -
24-inch, Rubbermaid Commercial Maximizer Dust Mop Refill with Hook & Loop Backing
$18.98 $10.44The 24-inch Rubbermaid Commercial Products Maximizer Dust Mop Pad is made to clean and dust for the long haul. Designed with durability in mind, the all-sewn construction can be commercially washed up to 40 times without bleach. The hook-and-loop back attaches securely to the frame, so you don’t have to worry about it coming loose—a handy feature when you’ve got a long cleanup ahead. This dust mop pad is ready to go when you get it. It’s been pre-treated so it will work just right the first time you use it. Designed to perform in a variety of common spaces, Maximizer cleaning tools deliver fast, consistent results shift after shift.
Every item checked for quality -
Commercial Electric 3-Watt 150 Lumens Low-Voltage Gun Metal Motion Sensing LED Bollard
$59.96 $32.98This Upgraded Low Voltage 12-Volt Landscape Bollard has Dusk to Dawn timer and also motion sensor. Bollard will automatic turn on during low light hours (50 Lumens, eq 5-Watt) and when motion is detected within 18 ft., the bollard will brighten to 300 Lumens (eq. 25-Watt) for 5-Minutes. Commercial grade quality construction and with an elegant Gun Metal Finish for Residential use. Fully integrated LED Technology means not need to replace any bulbs. Equipped with new and improved Low voltage wire connector for easy installation.
- Bollard with 2 brightness setting active by motion.
- 3-Watt – 50 and 300 Lumens.
- Sturdy cast aluminum construction.
- Stylist gunmetal finish.
- Integrated LED technology, not bulb to replace.
- Per-wired with upgraded low voltage wire connector.
Every item checked for quality -
Cap A Tread Bennett Valley Oak/Kettle Hill Oak 47in.Lx12.15in.Wx2.28in.T Vinyl Stair Tread and Reversible Riser Kit Adhesive
$66.96 $36.83Cap A Tread is a durable, seamless stair tread cover that is easily glued down over your existing stair treads. Use Cap A Tread to renew your stairs in a day to a fresh new look! Coordinates with many vinyl and laminate plank flooring colors.
- Buy the correct size for your existing treads: 1.69 in. Thick Cap A Tread will cover existing stair treads up to 1.3 in. thick; 2.28 in. Thick Cap A Tread will cover existing stair treads up to 1.9 in. thick.
- Cap A Tread adds character to your stairs, product visuals are designed to closely coordinate with flooring as there may be slight color and texture variation.
- Durable, seamless cover laminated over MDF.
- Coordinates with many flooring types and thicknesses, including vinyl and laminate plank flooring.
- Easy glue down installation to coordinate stairs with your floor.
- Designed to coordinate with many flooring colors, or can be used as a standalone retrofit for an existing stair finish, such as carpet.
- Allows the customer to achieve a great new look that is affordable.
- Cap A Tread fits over existing treads without having to modify them.
- Simply cut to fit and glue over the existing stair tread.
- For residential and light commercial use; interior use only.
- Easy to clean with just a damp cloth.
- Tread and riser kit includes a reversible riser that is white on one side and matching color on the other.
- Proudly manufactured by Zamma Corporation.
- Use only urethane based adhesive to install Cap-A-Tread.
Every item checked for quality -
EcoSmart 75-Watt Equivalent BR40 Dimmable ENERGY STAR LED Light Bulb Soft White (2-Pack)
$10.47 $5.76Upgrade your current lighting with the EcoSmart 75-Watt equivalent BR40 Dimmable Flood LED Light Bulbs. Use these bulbs to replace your traditional incandescent bulbs-with all the benefits of LED technology. Save on your energy bill every month. Rated to last for 15,000-hours and estimated to cost only $1.45 per-year to operate, these energy efficient BR40 LED light bulbs will reduce household energy costs by using 85% less energy than traditional incandescent bulbs. Using only 12-Watt to produce 945 Lumens of Soft White (2700K) light, these flood lights produce brightness equivalent to a 75-Watt incandescent light bulb. The soft white color temperature is essential in creating a relaxing, balanced feel throughout your home. It is recommended for living rooms, kitchens, bathrooms and bedrooms. Customize your lighting style with this dimmable bulb by adjusting your light from soft white to a relaxing, low light. Suitable for use in enclosed fixtures and ideal replacement bulbs for indoor recessed and track lighting. Start saving today with EcoSmart.
- Brightness: 945 Lumens.
- Estimated yearly energy cost: $1.45 (based on 3-hours/day, 11/kWh, costs depend on rates and use).
- Life: 13.7-year (based on 3-hours/day).
- Light appearance: 2700K (soft white).
- Energy used: 12-Watt (Equivalent to a 75-Watt standard incandescent bulb).
- Energy used: 12-Watt (equivalent to a 75-Watt standard incandescent light bulb).
- Fully dimmable with a shadow-free experience.
- Ideal for use in totally enclosed fixture.
- Damp locations rated.
- LED light bulb does not contain mercury.
- Energy efficient.
Every item checked for quality -
Cortag 1/16 in. Hard Plastic Leave-In Spacer (1,000 pack)
$8.35 $4.59
1/16″ Hard plastic hollow leave-in Spacers. 1000 unit sealable jar of Hard plastic hollow leave-in Spacers. Calibrated for a precise installation, these spacers can be left in the joint and covered with grout, speeding up the installation process.
- The extra-long arms are reinforced to hold larger and heavier format tiles.
- Provides precise aligned placement.
- Reduced installation time.
- When left in place, prevent displacement of wall tile and floor tile.
Every item checked for quality -
Husky 50 ft. 16/2 Indoor/Outdoor Extension Cord, Green
$17.96 $9.88This Husky 50 ft. 16/2 2-pronged Extension Cord is versatile for indoor/outdoor job sites and household use. Rated for 13 Amp and 125-Volt. Reinforced blades and molded plugs prevent accidental bending and breaking. cULus Listed. Medium-duty, Durable and Flexible.
- Durable cord is designed to withstand temperatures from minus 40°F up to 167°F.
- 50 ft. 2-prong extension cord may be used with power tools and appliances for light duty applications inside and outside of your homes.
- For indoor/outdoor use.
- 13 Amp, 125-Volt, 1625 maximum watt capacity.
- Each plug has 2 prongs.
Every item checked for quality -
