Every item checked for qualityShowing 1–9 of 260 results
-
BrassCraft 1/2 in. MIP x 1/2 in. MIP x 36 in. Gas Connector (3/8 in. O.D.) w/Safety+Plus2 Thermal Excess Flow Valve (33,400 BTU)
$27.27 $15.00BrassCrafts Safety+PLUS2 gas connector combines patented excess flow technology and thermal heat activation with the advanced corrosion resistance, to provide a safer gas connector for your home and family. In the event of a gas line rupture or disconnect, the excess flow valve (EFV) restricts gas flow at the appliance to a non-hazardous level. This immediate action helps avert the potential for a dangerous release of gas into the home. Gas is controlled only at the point where the problem exists; the rest of your system will continue to function. Safety+PLUS EFV automatically resets once the gas line is properly repaired. The thermal component utilizes a thermal ring that will restrict the flow through the valve when the valve is exposed to temperatures of 400F or more. BrassCraft’s stainless steel gas connector also features a proprietary polymer coating designed to withstand prolonged exposure to harsh household cleaning, plumbing repair and masonry products as well as UV rays and salt. Unlike conventional dipped or sprayed coatings, the ProCoat coating is baked directly on the connector surface at high temperatures to provide a uniform coating over the entire length of the connector. The coating is applied only after the connector has been 100% leak tested to provide complete corrosion resistance.
- Corrugated stainless steel with corrosion resistant coating.
- 1/4 in. I.D. (3/8 in. O.D.).
- Connectors and fittings can be used with natural gas, LP gas (propane) and LP gas-air mixtures.
- Use to install 4-burner gas ranges, cook-top, dryers and water heaters.
- The Safety+Plus2 TEFV valve helps protect against fires and explosions.
- Valve has no parts that can break or misalign over time for 24/7 protection.
- Connector and valve are 100% leak tested.
- No special tools required for installation.
- ProCoat coating corrosion resistant to most household chemicals, UV rays and salt.
- Approved for indoor and outdoor use.
- Temperature rating: -20°F to 150°F.
- Pressure rating: 1/2 psi maximum.
- ANSI Z21.24-2015/CSA 6.10-2015 and ANSI Z21.75-2016/CSA 6.27-2016, ANSI Z21.93-17/CSA 6.30-17.
- Designed, machined and assembled in the USA.
Every item checked for quality -
1.25 in. Center Stop PVC Coupling Conduit Fitting
$1.51 $0.83This connector consists of two solvent weld female ends. A center stop ensures positioning of conduit. The coupling is made of rigid PVC.
- Connects conduit of the same diameter.
- Non-corrosive PVC construction.
- Joins metal conduit to PVC conduit or PVC to PVC.
- UL and CSA safety listed for greater safety and peace of mind.
Every item checked for quality -
KODO 120-Watt Equivalent PAR38 LED Motion Sensor Flood Light Bulb Bright White (2-Pack)
$19.87 $10.93The KODO LED Motion Activated Security Floodlights easily convert existing outdoor flood lights to LED motion sensing security lights in seconds. The built-in radar motion sensor detects motion within a 35 ft. range and keeps lights on for 5 minutes after the last detected movement. The sensor detection angle is 100°. Radar technology is more reliable and longer lasting than traditional infrared sensing. The built-in daylight sensor keeps daytime motion from triggering the lights. For 24/7 operation, the motion and daylight sensors can be easily deactivated by a simple flip of the light switch. Great for under eaves, backyards, driveways, doorways and more.
- Radar motion sensor up to 35 ft. turns on lights for 5-minutes.
- 100° detection angle.
- Daylight sensor keeps daytime motion from triggering the lights.
- Easily deactivate sensors to allow for constant 24/7 bulb operation.
- Switch lights ON for normal motion sensor mode.
- Switch OFF, then back ON (within 3-seconds) for always-on, 24/7 operation.
- Switch OFF (for longer than 3 seconds) then back ON to re-activate motion sensor mode.
- 120-Volt, E26 PAR38 bulbs, non-dimmable, 2-pack.
- 1200 Lumens each bulb.
- Not for use with existing motion sensor fixtures.
- Light appearance: 3,000K (bright white).
Every item checked for quality -
Husky 50 ft. 16/2 Indoor/Outdoor Extension Cord, Green
$17.96 $9.88This Husky 50 ft. 16/2 2-pronged Extension Cord is versatile for indoor/outdoor job sites and household use. Rated for 13 Amp and 125-Volt. Reinforced blades and molded plugs prevent accidental bending and breaking. cULus Listed. Medium-duty, Durable and Flexible.
- Durable cord is designed to withstand temperatures from minus 40°F up to 167°F.
- 50 ft. 2-prong extension cord may be used with power tools and appliances for light duty applications inside and outside of your homes.
- For indoor/outdoor use.
- 13 Amp, 125-Volt, 1625 maximum watt capacity.
- Each plug has 2 prongs.
Every item checked for quality -
HDX 50 Ft. 16/3 Tri-Tap Indoor/Outdoor Landscape Extension Cord, Green
$15.87 $8.73This Medium Duty Home Accents Holiday 50 ft. Multi-Outlet Extension Cord provides power for various electrical equipment. This kink free cord is designed for indoor and outdoor applications. This extension cord also features multiple outlet to provide power for more appliances. Color: Green.
Every item checked for quality -
RYOBI Rotary Tool Coarse Flame Material Removal Burr (For Wood, Plastic, Fiberglass and Drywall)
$20.96 $11.53Introducing the Rotary Tool Coarse Flame Material Removal Burr. This burr is ideal for aggressive flowing, concave and v-shaped cuts and offers 11X more material removal than standard burrs. Proudly made in the USA. This accessory offers universal fitment and is compatible with any rotary tool including Dremel. Expand your hobby and maker capabilities with this RYOBI accessory.
- For Aggressive Flowing, Concave, and V-Shaped Cuts.
- For use on wood, plastic, fiberglass, and drwyall.
- 11X More Material Removed Than Standard Burr.
- 1/8 in. Shank.
- 35,000 Max RPM.
- USA Made.
Every item checked for quality -
Charlotte Pipe 3 in. PVC DWV No Hub Adapter
$7.62 $4.19PVC fittings are for drain, waste and vent purposes. They are used in gravity-fed waste elimination systems and are for Non-Pressure systems where temperatures will not exceed 140°F. PVC is lightweight and easy to install. They require no special tools for cutting, and can be installed with solvent cementing, threading, flanging, and roll-grooved joining.
Every item checked for quality
